RNB130
Primary switched-mode power supply for DIN rail
Power supply for one 4 wire sensor or transmitter.
-
©Endress+Hauser
The power supply has one output for supplying voltage to 4 wire sensors and transmitters. Connection to mono-phased a.c. networks or to two phase conductors of three-phase supply networks (TN-, TT- or IT-networks as per VDE 0100 T 300/IEC 364-3) with 100-240 V AC nominal voltage possible.
Lợi ích
Small housing, 35 mm width
High availability
Wide range input - can be used world-wide
Power reserve (Power Boost)
Power supply without wiring: Supply via DIN rail bus connector
Space saving DIN rail mounting as per IEC 60715
Phạm vi ứng dụng
Voltage supply for sensors. Connection to mono-phased a.c. networks or to two phase conductors of three-phase supply networks (TN-, TT- or IT-networks as per VDE 0100 T 300/IEC 364-3) with 100-240 V AC nominal voltage.
Tín năng và thông số kỹ thuật
Tài liệu / Tài liệu hướng dẫn / Phần mềm
Phụ kiện / Phụ tùng thay thế
Liên hệ
Endress+Hauser Instruments International AG/ Asia Pacific Support Center
Unit 3, 1st Floor, CentrePoint Building 106 Nguyen Van Troi Street Phu Nhuan District Ho Chi Minh City Việt Nam
Điện thoại: +84 28 3842 0026
Gửi email